Need help?Do you have a question about the Inficon UL5000 and is the answer not in the manual?
General| Type | Helium Leak Detector |
|---|---|
| Pumping Speed (Helium) | 2.5 l/s |
| Detectable Gases | Helium (He) |
| Minimum Detectable Leak Rate (Helium) | 5 x 10^-12 mbar l/s |
| Response Time | < 1 second |
| Power Supply | 100-240 V, 50/60 Hz |
| Operating Temperature | 10°C to 40°C |
| Display | LCD |
| Detection Principle | Mass Spectrometer |
| Interface | RS-232 |
| Storage Temperature | -20°C to 60°C |
Explanation of safety symbols used throughout the manual for risk awareness.
Instructions for safely connecting the UL5000 to power and external systems.
Detailed steps for connecting the UL5000 to the main power supply.
Explanation of vacuum connections including inlet, exhaust, vent, and purge.
Step-by-step guide for the initial startup and measurement process.
Procedure for the initial startup and first measurement.
Steps to verify the UL5000's accuracy after setup or calibration.
Explains the key components and layout of the UL5000 vacuum system.
Explains the functions of the control panel, display, and buttons.
Details the different operational modes of the UL5000.
Describes the primary vacuum mode and its operational stages.
Explains the operation of the UL5000 in sniffer mode.
Covers how leak rates are displayed during measurement.
How to access the calibration routine from various modes.
Overview of the main menu structure and its sub-menus.
Selecting between different operational modes like Vacuum or Sniff.
Configuration for trigger levels, alarms, and volume.
Setting the first leak rate trigger level for alarms and outputs.
Setting the second leak rate trigger level for alarms and outputs.
Access point to the calibration routines for the UL5000.
Menu for configuring internal machine parameters and functions.
Settings related to the vacuum system's operation and functions.
Settings for background suppression and ZERO button functionality.
Selecting whether calibration menu access is restricted or not.
Describes the different ways to access and initiate the calibration process.
Details the procedure for internal calibration using a built-in standard.
Guide for performing external calibration with a separate leak standard.
A comprehensive list of all error and warning messages with possible solutions.
Outlines required maintenance tasks based on operating hours.
To Next Page
