Need help?Do you have a question about the Inficon HLD5000 and is the answer not in the manual?
General| Operating Temperature | 10 - 40 °C (50 - 104 °F) |
|---|---|
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Weight | 16 kg (35.3 lbs) |
| Detection Technology | Helium Mass Spectrometer |
| Response Time | <1 second |
| Refrigerants | Helium (He) |
| Minimum Detectable Leak Rate | 5 x 10^-12 mbar l/s |
| Sensor Type | Helium Mass Spectrometer |
Details the physical, electrical, and other specifications of the HLD5000 leak detector.
Lists physical characteristics, measurement ranges, and detectable refrigerants.
Covers mains voltage, power consumption, protection, and gas flow specifications.
Guides for setting up the HLD5000, including unpacking, connections, and mounting.
Explains the infrared gas analysis method used by the HLD5000 for leak detection.
Identifies and describes the main components and parts of the HLD5000 unit.
Procedures for conducting leak tests, moving the probe, and interpreting results.
Identifies and explains the function of all controls and display components.
Provides a visual overview and identification of all main unit controls and displays.
Configuration of leak rate settings (LEVEL, ALT LEVEL) and gas type selection.
Procedure for calibrating the HLD5000 using an external test leak or internal calibration.
Information on the built-in calibrated leak and the general calibration process.
Steps to verify the current calibration status and determine if recalibration is needed.
Detailed guide for performing calibration using the COOL-Check device.
Instructions for replacing the filters in the sniffer line and the main unit housing.
To Next Page
