Infineon IMC300A Series - Troubleshooting FAQ

V 1.2
page 12 of 15 2021-07-22
IMC301/302A MCU Getting Started Guide
Troubleshooting FAQ
3 Troubleshooting FAQ
Q Why can’t I find the iMOTION Link when I scan?
A In order to scan for the iMOTION Link port must be set to “SW” (Serial Wire) interface.
Q Why do I get “No J-Link found” pop up when I try to “Load” firmware?
A Debugger settings may be incorrect for the target. Please refer to section 2.3 on how to setup the
debugger.