Infineon IMC300A Series - Setting up J-LINK;J-TRACE Cortex as debugger

V 1.2
page 5 of 15 2021-07-22
IMC301/302A MCU Getting Started Guide
Getting Started
4) Agree to the “Terms of Service” and click “Next” as shown in Figure 4.
Figure 4 iMotion™ Software License Agreement
5) To confirm IMC300A DFP has been installed look under “All Devices” → “Infineon” → “iMotion” and one
should see the IMC300 Series as shown in Figure 5.
Figure 5 Keil µVision® IDE Pack Installer Window
2.3 Setting up J-LINK/J-TRACE Cortex as debugger
1) Connect iMOTION™ Link to EVAL-M1-301F/EVAL-M3-302F or use the on-board debugger using USB
connection.
a. Please refer to the User Manual of the correlated board to connect iMOTION™ Link to MCU.