Infineon IMC300A Series - Page 6

V 1.2
page 6 of 15 2021-07-22
IMC301/302A MCU Getting Started Guide
Getting Started
2) In µVision® IDE open a use case code example from
https://www.infineon.com/cms/en/product/power/motor-control-ics/digital-motor-controller-
imotion/ or start a new blank project.
3) Select “options for target” next to the “Select Target” dropdown menu as shown in Figure 6.
Figure 6 Keil µVision® IDE Options for Target
4) Go to the “Debug” tab and select “J-LINK/J-TRACE Cortex” from the drop-down menu on the right side
of the page as shown in Figure 7.