17 of 20
2022-05-16
XENSIV™ 60GHz BGT60TR13C Radar System on Module MCU4
9 Firmware update
A firmware update can be done under the “Firmware update” tab. Select the target .bin file by pressing the
“Select” button. Bootloader mode will be entered automatically during the update process. In case non-
working firmware is loaded, the user can manually force the module to enter bootloader mode by pressing the
user button on the motherboard after power-up or reset. The LED will change to blue when bootloader mode is
entered.
Figure 13 Firmware update tab page
Press the “Flash” button to start the firmware update. The whole update process should take around 20 s.
Although a protection mechanism is included in the update process, it is recommended not to unplug the USB
or power off the board to prevent any unexpected errors.
Figure 14 Firmware update in process
To Next Page
Loading...