Infineon XMC4700 - Example 2: Radarpulseddoppler_Andee_Rgb

20 of 31
2019-12-02
Using Infineon’s radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Set-up guide
Software set-up
6. Upload the code onto the board by clicking the “Upload” button (Figure 22).
Figure 22 Uploading code onto board
The application can now be tested. Make some movements in front of the radar board and observe the LED
colors depending on the motion and its direction (Figure 23).
Table 5 LED color based on motion for Example 1
LED color
Type of motion
Off
No motion
Red
Departing
Green
Approaching
Blue
Motion with no meaningful direction
Figure 23 Observe LED color change with motion
3.4.2 Example 2: RadarPulsedDoppler_Andee_RGB
This section lists the steps to follow to get this example up and running.