Infineon XMC4700 - Page 24

24 of 31
2019-12-02
Using Infineon’s radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Set-up guide
Software set-up
Figure 30 Jumper wire connections on the Andee U
7. Turn on the 24 V DC power supply to the RGB LED lighting shield and connect the radar baseboard XMC4700
to the PC via a USB cable onto the “Debug” USB port (Figure 31).
Figure 31 Connect the USB cable onto the debug port
8. Upload the code onto the board by clicking the “Upload” button (Figure 32).