Infineon XMC4700 - Page 26

26 of 31
2019-12-02
Using Infineon’s radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Set-up guide
Software set-up
Figure 35 Andee app – connect to device
11. Upon successful connection, the GUI should appear on the app (Figure 36). In case this does not happen,
disconnect from the app, press the reset button on the radar baseboard XMC4700 and retry the connection.
Make some movement in front of the radar board and observe the measured speed and detected direction
on the GUI. You may also observe the light from the RGB LED changing with regard to the motion and its
direction (Table 6).
Figure 36 Andee app – GUI upon successful connection