Infinite Peripherals 216 - Table of Contents

To Next Page

To Previous Page

TABLE OF CONTENTS

KPM210/216

INTRODUCTION

MANUAL CONTENTS ....................................................................................1

EXPLANATORY NOTES USED IN THIS MANUAL ......................................1

GENERAL SAFETY INFORMATION.............................................................1

UNPACKING THE PRINTER .........................................................................2

PRINTER FEATURES ...................................................................................3

PRINTER DESCRIPTION .............................................................................4

1. INSTALLATION AND USE

1.1 CONNECTIONS ................................................................................... 1-1

1.1.1 Power Supply ................................................................................. 1-1

1.2 CONFIGURATION ............................................................................... 1-2

1.3 HEXADECIMAL DUMP ........................................................................ 1-3

1.4 MAINTENANCE.................................................................................... 1-3

1.4.1 Changing the paper roll .................................................................. 1-3

1.4.2 Paper load specifications .............................................................. 1-4

1.4.3 Adjusting paper width..................................................................... 1-6

1.4.4 Paper jams ..................................................................................... 1-7

1.4.5 Cleaning the print head .................................................................. 1-9

1.4.6 Cleaning the ejector rollers ...........................................................1-11

2. INTERFACES

2.1 RS232 SERIAL .................................................................................... 2-1

2.2 USB SERIAL (OPTIONAL) .................................................................. 2-3

3. PRINTER OPERATION

3.1 PRINTING MODES .............................................................................. 3-1

3.2 CONTROL CHARACTERS ................................................................. 3-2

3.2.1 ESC/POS emulation ..................................................................... 3-2

4. TECHNICAL SPECIFICATIONS

4.1 TECHNICAL SPECIFICATIONS ......................................................... 4-1

4.2 DIMENSIONS....................................................................................... 4-5