3. PRINTER FUNCTIONS3. PRINTER FUNCTIONS
KPM210/216
253-
nGCSEnGCSE
nGCSE
nGCSEnGCSE
[Name] Turn double-strike mode on/off
[Format] ASCII ESC G n
Hex 1B 47 n
Decimal 27 71 n
[Range] 0 ≤ n ≤ 255
[Description] Turns double-strike mode on or off.
• When the LSB of n is 0, the double-strike mode is off.
• When the LSB of n is 1, the double-strike mode is on.
[Notes] • Only the LSB of n is effective.
• Printer output is the same in double-strike and emphasized
mode.
[Default] n = 0
[Reference] ESC E
[Example]
nJCSEnJCSE
nJCSE
nJCSEnJCSE
[Name] Print and paper feed
[Format] ASCII ESCJ n
Hex 1B 4A n
Decimal 27 74 n
[Range] 0 ≤ n ≤ 255
[Description] Prints the data in the print buffer and feeds the paper [ n ×
(vertical or horizontal motion unit)] inches.
[Notes] • After printing has been completed, this command sets the
print starting position to the beginning of the line.
• The paper feed amount set by this command does not af-
fect the values set by ESC 2 or ESC 3.
• The horizontal and vertical motion units are specified by
GS P or GS $D0.
• GS P or GS $D0 can change the vertical (and horizontal)
motion unit. However, the value cannot be less than the mini-
mum vertical movement amount.
• In standard mode, the vertical motion unit is used.
• The maximum paper feed amount is 4095 mm (161
inches).
[Default]
www.ipcprint.com
To Next Page
Loading...