3. PRINTER FUNCTIONS3. PRINTER FUNCTIONS
KPM210/216
573-
[Notes] • Printing density reverts to the default value when the printer
is reset or turned off.
[Default] n = 4
[Reference]
[Example]
n~SGn~SG
n~SG
n~SGn~SG
[Name] Set superscript/subscript
[Format] ASCII GS ~ n
Hex 1D 7E n
Decimal 29 126 n
[Range] n = 0, 1, 48, 49
[Description] Sets superscript or subscript character position.
n specifies the position as follows:
nnuFnoitc
84,0noitisopretcarahctpircsbuS
94,1noitisopretcarahctpircsrepuS
[Notes] • This command is executed if there are characters of differ-
ent height on the same line.
[Default] n = 0
[Reference] ESC !, GS !
[Example]
)2edom(LyHyLxHx0D$SG)2edom(LyHyLxHx0D$SG
)2edom(LyHyLxHx0D$SG
)2edom(LyHyLxHx0D$SG)2edom(LyHyLxHx0D$SG
[Name] Set horizontal and vertical motion units
[Format] ASCII GS $D0 xH xL yH yL
Hex 1D D0 xH xL yH yL
Decimal 29 208 xH xL yH yL
[Range] 0 ≤ ((xH * 256) + xL) ≤ 2040
0 ≤ ((yH * 256) + yL) ≤ 4080
[Description] Sets the horizontal and vertical motion units to 1/((xH * 256) +
xL) inch and 1/((yH * 256) + yL) inch respectively.
When x is set to 0, the default setting value is used.
www.ipcprint.com
To Next Page
Loading...