Infinity 1380-S1 - Error Code

37
12. Error code
Error
error
code
Issues
Simple processing method
E01
Signal
communication
failed
Communication between the electronic
control and the electronic watch is blocked.
Check each connection between the
electronic watch and the lower control
communications line to ensure each core is
fully inserted. Check whether the connecting
line between the electronic watch and the
controller is damaged and replace the
connecting line.
E02
Explosion
protection
Check that the supply voltage is lower
than 50% of the normal voltage. Retest with
the correct voltage specification; check if the
controller has a strange smell and replace the
controller; check that the motor wire is
properly connected and reconnect the motor
wire.
E03
No sensor signal
If the speed sensor signal is not detected
for 5-8 consecutive seconds, check whether
the sensor plug is not properly connected or
the sensor is damaged. Connect it or replace
the sensor; or if the engine signal is not
detected for a longer period of time. then 5-
8 seconds Input, the motor cable is not
properly connected or the motor is defective.
E04
Ascension
learning fails
Check whether the VR line of the lifting
motor is connected properly, and reconnect
and disconnect the VR line connector to
make it reliable; check whether the AC line
of the lifting motor is connected correctly
and the AC line of the lifting motor motor is
correctly connected to the mark on the
controller; check Check whether the motor
connecting wire is damaged and open
circuit, replace the connecting wire or lift the
motor; After checking everything, press the
learn button on the controller to learn again.