IMVO SAFET¢INSTRUCTIONS
I) l_d _-, -/dl the safetyand operatingimm_ous should
be read before the p_roduct is operated.
2) Retain hstructlom - The safety and operatingin.m'uctionsshould
be retainedfor fiamrereference.
5) HeedWarnings- Allwarningson the productand in the operating
instructionssha,_l beadheredto.
4) Folio,#Iastmalons - All operatingand use instructions should be
followed.
5) Cleaning- Unplugthisproductfrom the walloudet beforedeaning.
Do notuseliquidcleanersoraerosoldeanets. Usea dampdoth for dean-
ing. ExceptiomA product thatis meant for uninterrupted serviceand
that for some specific reason,such as the possibilityof the loss of an
anthorizadon code for a CATVConverter, is not intended to be
unpluggedbythe userfor deaniugoranyotherpurpose,may ear.ludethe
reieereficeto unpluggingthe productin thedeanhg descriptionotherwise
requiredabove.
6-) Attachments - Do not use attachments not recommendedby the
product manufacuaer as they maycausehazards.
7) Water and Moisture- Do not use this product near water - for
example,neara bath tub, washbowl,kitchen sink, orlaundrytub; in a
wet basement;,ornear a swimmingpool; and the like.
8) Accessories- Do not phce this product onan unstablecart, stand,
tripod, bracket,or table. The product mayfall, causingseriousinjury to
achildor adult, and seriousdamageto the product. Useoulywithacart,
stand, tripod, bracket,or table recommended by the manufacturer,or
sold with the,product. Any mounting of the product should followthe
manufacto_,_sinstructions, andshould usea mountingaccessoryrecom-
mended by the manufacturer.
9) A product andcartcombinationshould be movedwith care. Quick
stop,excessiveforce,andunevensurfacesmay causethe product and cart
combinationto overturn.
I0) Ventilation- Slotsand openingsin the cabinetareprovidedforven-
tihtiun and to ensu_ reliableoperationof the productand to protect it
from overheating,and these openingsmustnot be blockedor covered.
Theopeningsshould neverbe blockedbyplacingthe producton a bed,
sofa,rug,or other similarsurface.Thisproduct should notbe placedina
built-in installationsuch as ab_,keaseor rack unless properventilation
is providedorthe manufacturers instructionshavebeen adheredto.
11) PowerSources- Thisproduct shouldbeoperatedoulyfrom thetype
ofpowersourceindicatedon the markinglabel.Ifyou arenot sureofthe
type of power supplyto your home, consultyour productdealerorlocal
powercompany.Forproductsintendedto operatefrom batterypower,or
othersources,referto the operatinginstructions.
12) Grounding orPolarlzation- This product maybe equipped with a
polarized alternatlng-current line plug (a plug having one blade wider
than theother).Thisplugwillfitinto thepoweroutletonlyone waFThis
is a safetyfeature.If you areunable to insertthe plugfullyinto the out-
let, try reversingthe plug. If the plug should stillfail to fit, contact your
electricianto replaceyour obsoleteoudet.Do not defeatthe safetypur-
pose of the polarizedplug.
13) Power-CordProtection - Power-supplycords should be routedso
that they arenot likelyto be walkedonorpinched by itemsplacedupon
or against them, paying particular mention to cords at plugs,conve-
niencereceptacles,and the point wherethey exit from the product.
14) Outdoor Antenna Grounding - If an outsideantenna or cablesys-
tem is connected to the product, be sure the antenna orcablesystemis
_ru_l.undedso as-€o provide some protection against voltagesurges and
t-up static charges. Ardde 810 of the National ElectricalCode,
ANSI/NFPA70, providesinformation with regardto proper grounding
ofthe mastand supportingmuctu_ groundingof the lead-inwireto an
antenna discharge"unit, sizeof grouncling"conductors,location ofanten-
na-dischargeunit, connection togroundingdectrodes,and requirements
for the groundingdectrod_ Seethe followingfigure.
NqTI_HA
a--""_ IT=AD Uq
_P.E
• _'/ ,/h_ITE;_IA
l
DISCHARGE UNIT •
(/dEC SECTION 810-21)
•GROUNDING COf, RXJCTORS
EmCTmC_ I _-_ I I - J (N_C_C'no_e*0-2_)
s_ce. -'--.-bn-I / / /
GROUND CLAMPS
(NEC SECTION 810-211
15) Lighming- Foradded protectionforthisproduct duringa lighming
storm,or whenit is leftunattendedand unused for longperiodsof time,
unplug it fromthe walloutletand disconnectthe antenna or cablesys-
tem. This will prew_ntdamage to the product due to lightningand
power-linesurges.
16")PowerLines- An outsideantennasystemshould not be locatedin
the vidnity of overheadpowerlinesor otherdectriclight or power cir-
cuits, or where it can fall into such power lines or circuits. When
installingan outsideantenna system, extremecare should be taken to
keep from touching such power lines ordrcuitsas contact with them
mightbef=£.
17) Overloading- DOnot overloadwalloudets,extensioncords,orinte-
gralconveniencereceptaclesas this can resultin a risk of fireordectric
shock.
18) Object and LiquidEntry- Neverpush objectsofany kind into this
productthrough openingsas theymaytouch dangerousvoltagepoints or
short-ourparts that could resultin a fireordectricshock.Neverspill liq-
uid of any kind on the product.
19) Servicing- DOnot attempt to servicethisproduct yoursdf asopen-
ingorremovingcoversmayexposeyou to dangerousvoltageorotherhaz-
ards. 1_e.ferall servicingto qualifiedservicepersonnd.
20) DamageRequiringService- Unplugthisproduct from thewallout-
letand referservicingto qualifiedservicepersound under the following
conditions:
a) Whenthepower-supplycordorplugisdamaged.
b)If liquid hasbeenspilled,orobjectshavefalleninto theproduct.
c) If the product hasbeenexposedto rain orwater
d) If the product doesnot operatenormally byfollowingthe operating
instructions.Adjustonlythosecontrolsthat arecoveredbythe operating
instructionsasan improperadjustmentof othercontrolsmayresultin
damageand willoftenrequireextensiveworkbya qualifiedtechnicianto
restorethe productto its normaloperation.
e) If the product hasbeendroppedordamagedin any wa_
f) When the productexhibits a distinctchangein performance- this
indicatesa needfor service.
21) Ik'placementParts- When replacementpartsarerequired,besurethe
servicetechnicianhas usedreplacementpartsspeci_edbythe manufactur-
er or that have the same characteristics as the original part. Unauthorized
substimdonsmayresultin fire,dectricshock,orotherhazards.
22) Sak_ Check - Upon completion of any serviceor repairsto this
product,asktheservicetechnicianto performsafetychecksto determine
that the product is in proper operatingcondidon.
2.3)Wallor CeilingMounting - The productshould be mountedto a
wallorceilingonlyasrecommendedbythe manufacturer.
24) Heat- The product shouldbe situatedawayfrom heatsourcessuch
asradiators,heatregisters,stoves,orotherproducts(includingamplifiers)
that produceheat.
P/N 330100-O01
To Next Page
Loading...
