Infinity OVTR 1 - Installing Feet and Grilles; Vertical Placement; Horizontal Placement

VERTICALPLACEMENT...
Figure 4. This illustration shows how
to install a molded foot for the
vertical p[acement of a Compositions
Overture OVTR I speaker.
HORIZONTAL PLACEMENT...
Figure 5. This illustration shows how
to install self-adhesive feet for the
horizontal placement of a
Compositions Ove_ure
OVTR I speaker.
INSTAI22NG FEET AND GRmLES
Compositions Overture 0VTR 1 speakers include two types of feet for
vertical or horizontal placement on a shelf, table, or speaker stand.
To insure proper woofer firing, temporarily position the speakers so that
the woofer grilles face each other. On each molded foot, peel the backiv, g
from the self-adhesive tape and press each foot into its respective slot,
as shown in Figure 4. Insert a grille into each speaker, so the logo is
nearest the foot. Flip each speaker ovei" and place them in your system.
OVTR1
(verticalrearviewswith
woofersfacingeachother)
0 PeelBackingFromTape
(ontopoffoot).
• PlaceFootInto SlotAnd Firmly
PressAgainstSpeakerBottom.
Place two small self-adhesive feet on each speaker bottom, as shown in
Figure 5. Depending on where you plan to put the speaker (e.g., TV top),
place two large self-adhesive feet 4 to 6 inches away (refer to Figure 5).
Insert a grille into each speaker, so the logo is nearest the foot. Flip
each speaker over and place them in your system.
0VTR1
(horizontal sideview
wooferontop)
O PeelBackingFrom(2) LargeAnd
(2) SmallSelf-AdhesiveFeet.
4 * Compositions Overture OVTR 1 - Owner's Manual