authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and
receiver.
l Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV
technician for help.
This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment.
Body-worn Operation
This device was tested for typical body-support
operations. To comply with RF exposure requirements, a
minimum separation distance of 0.5cm must be
maintained between the user's body and the handset,
including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain
any metallic components. Body accessories that do not
meet these requirements may not comply with RF
exposure requirements and should be avoided. Use only
the supplied or an approved antenna.
We, IRay Technology Co., Ltd., hereby declare that this
product was tested conforming to the applicable FCC
rules under the most accurate measurement standards
possible, and that all the necessary steps have been
taken and are in force to assure that production units of
the same equipment will continue to comply with the
Commissions requirements.
15
ENGLISH14 ENGLISH
To Next Page
Loading...
Need help?
General
