InFocus IN10 Reference Guide

2
Table of Contents
Introduction 3
Connecting a computer 5
Required computer connections5
Displaying a computer image 6
Adjusting the image 7
Connecting a video device 8
Shutting down the projector 9
Troubleshooting your setup 9
Using the keypad buttons 16
Using the remote control 17
Optimizing computer images 18
Presentation features 18
Optimizing video images 18
Customizing the projector 18
Using the menus 19
Picture menu 20
Settings menu 23
Maintenance 26
Cleaning the lens 26
Cleaning the lamp filter screens 26
Using the security lock 26
Replacing the projection lamp 27
Appendix 29
Projected image size 29
Important Operating Considerations for Safety
• Place the projector in a horizontal position no greater than 15 degrees
off axis.
• Locate the projector in a well-ventilated area without any obstructions
to intake or exhaust vents. Do not place the projector on a tablecloth or
other soft covering that may block the vents.
• Locate the projector at least 4' (1.2 m) away from any heating or cooling
vents.
• Use only the power cord provided. A surge-protected power strip is
recommended.
• Refer to this guide for proper startup and shutdown procedures.
• Warning: Hg – Lamp contains mercury. Manage in accordance
with local disposal laws. See www.lamprecycle.org.
• In the unlikely event of a lamp rupture, particles may exit through the
projector side vents. When the projector is turned on, keep people,
food, and drinks out of the "keep out" area around the projector, as
indicated by the "X" area below.
Follow these instructions to help ensure image quality and lamp life over
the life of the projector. Failure to follow these instructions may affect the
warranty. For complete details of the warranty, see the Warranty booklet.
2’ / 0.6 m
3’ / 1 m

InFocus IN10 Specifications

General

Brand	InFocus
Model	IN10
Category	Projector
Language	English