21
Set up your InFocus
CAUTION
Do not block the slots and openings in the projector case.
They provide ventilation and prevent the projector from overheating.
When installing the projector close to a wall, make sure there is a gap as specified in the Users Guide
between the wall and the air exhaust vent.
Do not place the projector in the following locations.
Badly ventilated or narrow places, such as inside a closet or in a book case.
On soft surfaces such as a rug, bedding, blanket, and so on.
Do not cover the projector with a blanket, curtain, or tablecloth.
Badly ventilated locations such as inside an AV rack or cabinet.
Locations subject to high temperatures, such as near heating equipment.
Do not install the projector in an airtight location.
If the projector needs to be installed in an airtight location, it is vital to ensure that air conditioning and ventilation
equipment are also installed.
If the location is not sufficiently ventilated, heat exhausted from the projector will accumulate and could trigger the
projector's built-in protection sensors causing the projector to shut down.
Set up your InFocus
To Next Page
Loading...
Need help?
General
