InFocus IN76 User Manual

4
Connector Panel
The projector provides the following connection options:
• M1-DA/DVI (Digital Vi
sual Interface)
• HDMI™ (High Definition Multimedia Interface)
• Component (RCA)
• SCART RGB (you must enable this connector, see page 26)
•S-video
• Composite video (RCA)
See “Video connectors” on page 7 for details.
The projector also provides the following connectors:
• RS-232 for serial control (not included on the IN72)
• 12 volt DC output (see below)
12 volt DC output
The 3.5mm mini-jack trigger provides a 12 volt, 0.25 amp DC output. It pro-
vides a constant output while the projector is on. It has numerous uses. For
example, if you connect your projection screen to the 12 volt DC output
with the cable that came with your screen, when you turn on the projector
the screen will move down; when you turn the projector off, the screen will
return to the storage position.
M1-DA/
S-video
12 volt
DC output
component RCA
composite
HDMI
RS-232
(not on IN72)
DVI
RCA
12 volt DC output
+12v
ground
3.5mm plug
to, for example, screen relay (see screen manufacturer
for details)
http://www.pureglare.com.au

InFocus IN76 Specifications

General

Projection distance	6.1 m
Projection technology	DLP
Contrast ratio (typical)	3000:1
Screen size compatibility	0.88 - 4.57 \
Projector native resolution	SXGA (1280x1024)
Keystone correction, vertical	20 °
Lamp power	200 W
Light source type	Lamp
Service life of light source	3000 h
Serial interface type	RS-232
S-Video inputs quantity	1
Weight (imperial)	9.3 lbs
Dimensions (WxDxH)	360.7 x 360.7 x 119.4 mm
Offset	116 %
Power consumption (typical)	250 W
Operating temperature (T-T)	10 - 35 °C

Weight and Dimensions

Weight	4220 g