27
Troubleshooting and Maintenance
Reset the LiteShow II adapter
Soft Reset
A soft reset reboots the system with all user settings saved. Press the reset button for about one second. The LED turns off for two seconds, then the system reboots.
Hard Reset
A hard reset reboots the system with all factory default settings restored. Press the reset button for five seconds or more. The LED turns off for two seconds, then the
system reboots. This will remove all password protection you may have applied previously.
Category Issue Solution
Power LiteShow II has no power
LiteShow II Power LED is not lit
Verify the power supply connector is plugged into LiteShow II and a working AC power outlet.
Perform a hard reset.
Try a new LiteShow II power cord.
Connecting The LiteShow II device I want to con-
nect to is not showing up in my Lite-
Show Manager
Verify that the projector and the LiteShow II device are both turned on, and that the LiteShow II splash
screen is displaying.
Verify the wireless network strength on the LiteShow Manager software. Adjust the antenna angle on
the back of the adapter, if needed, to maximize the wireless network strength.
Connecting “Connect to Projector” option is not
available while using Windows XP
Installation requires Administrator privileges. The "Connect to Projector" option will not work with-
out Administrator privileges. Manually select the Wireless Network through the operating system
after LiteShow Manager starts.
To Next Page
Loading...
Need help?
General