32
Internet/Email I can't access my local network any-
more for email or for the internet,
after I have disconnected from the
LiteShow Manager
Peer-to-Peer: If you have disconnected from LiteShow II and are no longer presenting from your com-
puter to the projector, close the LiteShow Manager.
If the LiteShow Manager closed unexpectedly and you are unable to access your email/internet, re-
start the LiteShow Manager and close normally. This should cause your Wireless Zero Configuration
setting to be turned back on automatically.
Otherwise, the Wireless Zero Configuration setting may need to be manually turned back on (XP:
Control Panel>Administration Services>Tools>Wireless Zero Services "enable").
Access Point: Check with your IT administrator to verify proper set-up of LiteShow II as an AP.
Internet/Email I have the LiteShow Manager open, but
can't project my local network (email,
Internet etc.) using the LiteShow II and
my computer
Peer-to-Peer: Activate a second wireless card on your computer or plug a standard network cable
from your computer into the closest network RJ45 connector.
Access Point: If you cannot access the network, contact your IT administrator to verify proper set-up
of LiteShow II as an access point.
If the network is accessible but cannot be displayed, refer to "The projector is not displaying the com-
puter's image" scenario above.
Error Messages An error message keeps appearing say-
ing that I must upgrade my wireless
driver
The LiteShow Manager has determined that your embedded computer or 3rd-party wireless card does
not meet the LiteShow II requirements. Although you may obtain an image on the LiteShow device,
unexpected results or undesirable quality may result. If you cannot upgrade your wireless card on the
manufacturer's website, it is recommended you try a different wireless card or connect your computer
to the projector using a computer cable.
Password The Advanced Properties window
requires a password
Your IT administrator has set a password up for this LiteShow II device. Check with your IT adminis-
trator for assistance. Note: The password is adapter specific.
Password I can't set my password up Up to 21 alphanumeric characters can be used, including underscores, dashes, and blank spaces.
Password I forgot my password Perform a hard reset.
Access Point: Contact your IT administrator for assistance.
Software I don't have the LiteShow Manager
software installed
There are three options to install the LiteShow Manager software:
1)Use the CD-ROM which came with the LiteShow II device.
2)If you have internet access, go to: www.infocus.com/support/LiteShowII
3)If the LiteShow II device is turned on, open Internet Explorer (or other browser utility) and type:
http://10.0.0.1, then click "Download Software".
Category Issue Solution
To Next Page
Loading...
Need help?
General