4
3. REQUIREMENT
3.1. Transportation
3.2. Placement
This product meets the safety requirements for devices to be operated in restricted access locations
according to EN 62040-1 safety standard, which states that the owner should
guarantee the following:
Access to the equipment can only be gained by service personnal or by users who have been
instructed about the reasons for the restrictions applied to the location and about any
precautions that shall be taken and,
Access is through the use of a tool or lock and key, or other means of security and is controlled
by the authority responsible for the location.
UPS is not designed for outdoor application.
The equipment and the batteries should not be exposed to direct sunlight or placed near to a
heat source.
Recommended operating temperature and humidity values are listed on the Appendix-1
Technical Specifications section. To provide the required enviromental condition.
Avoid dusty environments or areas where dust of conductive or corrosive materials is present.
The connection and the circuit breakers are at the front of UPS. Leave at least 75 cm at the front
of the UPS for maintenance.
Leave at least 75 cm from air outlets of the UPS for ventilation.
Even though the operating temperature of the UPS and batteries are between 0-40 °C, It is
suggested to provide an environment temperature between 20-25°C to get maximum
performance from the UPS and batteries.
Adviced Environmental humidity condition is between 20% 80% (non-condensing).
To Next Page
Loading...
Need help?
General
