EonStor DS S12/S16/S24 Series Hardware Manual
2.4.2 Placing Hard Drive into Drive Tray
Place the hard drive into the drive tray, making sure that the interface connector is
facing the open side of the drive tray and its label side facing up.
If you have a MUX board and you want to install a SAS drive, the MUX board should
be removed.
Installing a Hard Drive without a MUX Board (SAS drives)
Installing a Hard Drive with a MUX Board (SATA drives)
Adjust the drive location until the mounting holes in the drive tray are aligned with those on the
hard drive. Secure the drive with four of the supplied flat-head screws.
50
To Next Page
Loading...