EonStor DS S12/S16/S24 Series Hardware Manual
2.4.3 Inserting Hard Drive into Drive Tray
Once the hard drives have been installed in the drive trays, install the drive trays into
the subsystem.
WARNING
All drive bays must be populated even if it does not contain a hard drive. With one or
several empty bays, ventilation will be disrupted and the subsystem will overheat.
Make sure the rotary bezel lock is in the unlocked position as shown in the
figure below (i.e., the groove on its face is in a horizontal orientation). Use a
small-size flat blade screwdriver to turn the bezel lock.
Open the bezel by pressing the release button
Align the drive tray with a drive bay and then gently slide it in. Install the drive tray
with its bezel open. When a drive tray is fully inserted close, and lock the front bezel.
51
To Next Page
Loading...