• Hold the terminal in your one hand. Use two fingers from your other hand
to lift the printer cover release, as shown above.
• Unstick the end of the new roll. Carefully place the paper roll into the printer
compartment.
• Holding the free end of the paper and your terminal, close the printer cover
carefully and push it down firmly until it locks.
• While your terminal is displaying the idle screen, press and hold the Yellow
button to make sure the paper feeds correctly. You can only use paper rolls
that are 57mm wide and 40mm in diameter in your terminal. If you try to fit
bigger or smaller rolls into your terminal, you may damage it.
• Type of paper: Thermal paper
• Size: 57 x 41cm
15
To Next Page
Loading...
