Ingenico DESK/5000 - Configure CRE;RPE with Global Payments EMV

20 | P a g e
Configuring CRE/RPE for use with Global Payments EMV
You can configure CRE to communicate to the Pin Pad by following the step below.
1. Select the Manager or Options button.
2. Enter the administrator password
(default: admin) where applicable.
3. Select Setup(4) then, Setup Screen(G)
4. At the setup screen select the Payment
Processing tab
5. Select the Processing Tab
6. Select Credit/Debit
7. Select Global Payments Canada as the
Payment Processor from the dropdown
menu
8. Select TCP/IP under the Communication
Type section
9. Enter the IP Address being used by the
Desk/5000 pinpad from the print out.
10. Verify that Port No. is set to the #
entered in Step 7 when steeping up
communications.
11. Press Update