Ingenico IUC150B - 1.5 Professional installation Requirement

Integration guide iUC150B & iUC160B
900021059 R11 000 04/0416
Copyright© 2015 Ingenico
All rights reserved
19
1_5 Professional installation Requirement
Ingenico only sells its products, to qualied partners and integrators. They are in charge of professionally
resell, integrate, and install these products inside complete solution for end customers.
These end customers solution can be:
Petrol station.
Ticketing kiosk (Airline tickets, cinema, transport, etc.)
Vending machine operator
Parking kiosk (On / off street)
Other
Thus, the general public cannot purchase Ingenico hardware or software.
Partners, resellers, and Integrators must have qualied electronics engineers to be able to install
or integrate our products. Furthermore, they must follow a specic technical training conducted by
Ingenico technical experts.
In addition installation must follow Ingenico recommendations, as describe in this document, in order
to respect:
Local regulations for Electrical Safety and Radio emission levels
Ferrite beam installation
Our eld support & maintenance engineers are available for follow up and commissioning of installation.
1_6 Wake-up function
1_6_1 Wake-up mechanism
Device is designed to save power thanks to a “stand-by mode”.
If the stand-by mode is used, use Wake-up mechanism:
with button connected on go cless cable (optional)
with Pin 2 and GND of COM0 link
by pressing the green key on the maintenance keyboard of iUI120.
Wake-up pin state
Hz (high impedance) Stand-by authorized
Drive to "0"
Wake-up / Stand-by unauthorized
The Wake-up pin is drive to “0” by the one asking the wake-up.
It could be driven by iUP250, iUR250, iUI120 or any devices designed to be compliant (Host device…).