Ingenico IUC150B - 6.3 Product mounted on compact EVA plate

Integration guide iUC150B & iUC160B
900021059 R11 000 04/0416
Copyright© 2015 Ingenico
All rights reserved
41
6_3 Product mounted onstandard EVA plate
Product can be mounted on compact EVA plate. EVA plate is not provided by INGENICO. See the di-
mension detailed in the diagram below (all dimensions are in millimeters)
CAUTION
It is required by security regulation that EVA plate must be permanently mounted on the
kiosk (i.e. by soldering) and cannot be removed from the kiosk.
It requires a cut out in the kiosk to the dimensions detailed in the diagram below (all dimensions are
in millimeters).
Fixing must be done by 4 M4x25 welded studs.
RESERVATION AND FASTENERS INTO THE MACHINE FOR REAR MOUNTING
View from inside
4 weld stud M4x25
Footprint device
Picture of kiosk front panel preparation
CAUTION
It is important that the device footprint surface on the kiosk must be at and cleared
of any holes and burrs to prevent from dust and water penetration in the kiosk. (IP65
standard)
Rubber at the rear of the product guarantees waterproofness between EVA plate and
product.
Waterproofness between EVA plate and kiosk panel should be guarantee by installer.
3D step les are also available upon request.