Ingenico IUC150B - Maintenance and Cleaning; 7.1 Configuration

Integration guide iUC150B & iUC160B
900021059 R11 000 04/0416
Copyright© 2015 Ingenico
All rights reserved
46
7_Maintenance
7_1 Conguration
7_2
Operating life
The device supplied to you has operational conguration loaded.
In factory, software is loaded into product as well as parameter denition les.
The parameter denition le of the UCMC component is used, in particular, to determine the type of
printer used (local/host) and the position of the host (COMx).
To change conguration, you must load a new parameter denition le (supplied by Ingenico).
This operation can be performed using the LLT or a USB key (see § Loading by USB key)
For more information concerning conguration, contact Ingenico Technical Support.
Minimum operating life of 5 years.
8_Cleaning instructions
The external front face of the contactless reader should be carefully cleaned on a regular basis.
The goal is to keep the display and the keyboard free of dirt and solvents.
First of all, unplug all the wires from the terminal during this operation.
Good rules for proper cleaning of the terminal are :
Use a soft cloth that is very slightly soaked with soapy water to clean the outside of the terminal.
The glass has special surface treatment but must be carefully clean.
Do not clean the electrical connections.
Do not use in any case, solvents, detergents or abrasive products : Those materials might damage
the plastic or electrical contacts.
Avoid also the use of pressurized liquids.
Avoid exposing the terminal to the direct rays of the sun.