Corded Terminals - iCT250
If you have chosen the iCT250 terminal you will need to follow these instructions.
What’s in the box?
The iCT250 terminal handset
Paper roll
The Power Supply Unit (PSU)
A Magic Box with attached cables (see illustration on page 5)
A telephone (PSTN) cable
An ethernet cable
An ADSL lter
Cable ties
QUICK SETUP GUIDE
1. Connect the power supply unit to the power socket on the Magic Box. The socket
is located opposite the telephone and ethernet sockets.
2. If you are connecting via PSTN (Telephone), connect the black PSTN (Telephone) cable
to the socket on the Magic Box, marked with a picture of a telephone.
Connect the other end of the cable to the ADSL lter.
3. Connect the ADSL lter to a working telephone socket in the premises.
It is recommended that the terminal is the only equipment on the line.
4. If you are connecting via IP (Broadband), connect the purple ethernet cable to the
socket on the Magic Box marked with an ethernet symbol. ( ). Connect the other end
of the ethernet cable to a free ethernet port on your broadband router.
5. Plug the 3-pin plug for the power supply into an available power socket and the terminal
will power up.
6. We recommend that you secure the Magic Box using a cable tie (not provided).
If the Magic Box is not already connected to the terminal device, unclip the cover by
pushing the two clips down simultaneously. Then lift the cover up and to the rear of the
terminal.
4 Corded Terminal - iCT250
Your terminal will require charging for at least two hours prior to
‘Performing First Time Setup’ (p10)
To Next Page
Loading...
