17
4_4_2 Installing paper roll
Open the paper compartment by lifting the catch located at the
rear of the iWL280 and pull the cover to the rear of the terminal.
Insert the paper roll in the compartment following the directions
shown on the below picture.
Pull the paper up to the top of the terminal.
Maintain the paper and close the lid
Press simultaneously on both upper corners of the paper ap, as
shown by arrows on picture, until it clips into position.
ADVICE
If you insert a new R40 paper roll, tear off the rst length
(one complete turn to avoid printing on adhesive tape
footprint). This is not necessary on R25 paper roll as it has
no tape.
To Next Page
Loading...
