Move/5000
Setup Guide
Charge the Reader
• Unpack the reader, charger and base or
accessories.
• Make sure the reader is powered OFF.
• Connect wall/power charger to the card
reader directly [A] or to a base [B], [C].
• Charge for 16 hours.
Wall Charger
Base bottom
(for charging port)
Set up the Reader
• If using Wi-Fi to process payments, a
base isn’t required, but you may have
purchased a charging base (images A and
B). Follow instructions on page 2.
• If using Bluetooth to process payments,
you need a communications-enabled
base to connect the base via Ethernet.
Follow instructions on page 3.
Follow these steps to set up and use your
Move/5000 card reader.
A
C
Move/5000
Move/5000 with
Communications base
B
Charge-only base
To Next Page
