EasyManua.ls Logo

Ingersoll-Rand 2475 - User Manual

Ingersoll-Rand 2475
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
22607402
Revision D
May 2015
Save These Instructions
Two-Stage Reciprocating Air Compressors
Models 2340, 2475, 2545, 7100, 15T & 3000
Owner’s Manual
Manual del usuario
ES
Manuel de l’utilisateur
FR
Owner’s Manual
EN

Table of Contents

Questions and Answers

  • J
    Jeffery GriffinJul 27, 2025
    What to do if the timer will not activate on my Ingersoll-Rand 2475 Air Compressor?
    • R
      Rhonda GrantJul 28, 2025
      If the timer on your Ingersoll-Rand Air Compressor won't activate, several factors could be at play. First, ensure the unit is receiving power by checking the electrical supply. If power is present, the timer itself may be faulty and require replacement. Other potential issues include a clogged port, which necessitates cleaning the valve, a malfunctioning solenoid valve that needs replacing, or a clogged strainer, which should be cleaned.
  • D
    david71Aug 4, 2025
    Why will the valve not close on my Ingersoll-Rand 2475 Air Compressor?
    • J
      James LopezAug 5, 2025
      The valve may not close due to debris in the solenoid valve preventing the diaphragm from seating properly. To resolve this, remove the solenoid valve, disassemble it, clean all components, and then reassemble it. Another possible cause is a short in an electrical component. Inspect the power cord or timer and replace them as needed.
  • M
    matadouglasAug 12, 2025
    What to do if valve will not close on Ingersoll-Rand 2475?
    • D
      Derek SmithAug 12, 2025
      If the valve on your Ingersoll-Rand Air Compressor won't close, it could be due to debris in the solenoid valve preventing the diaphragm from seating. To fix this, remove the solenoid valve, disassemble it, clean it thoroughly, and then reassemble it. Another potential cause is a short in an electrical component. Inspect the power cord or timer and replace them if necessary.
  • L
    Laura WrightAug 19, 2025
    Why is the timer not activating on my Ingersoll-Rand 2475 Air Compressor?
    • M
      mckeemarkSep 12, 2025
      If the timer on your Ingersoll-Rand Air Compressor isn't activating, several factors could be at play. First, ensure there is an electrical supply reaching the timer. If there is no power, apply it. If power is present, the timer itself might be malfunctioning and need replacement. Other potential issues include a clogged port, which requires cleaning the valve, a malfunctioning solenoid valve needing replacement, or a clogged strainer that needs cleaning.

Summary

Application

General Information

Introduction

Provides safe and reliable instructions for installation, operation, and maintenance.

Two-Stage Operation

Explanation of Safety Signal Words

Receipt & Inspection

General Safety Rules

Selecting a Location

Electric Motor Compressors

Recommendations for choosing a suitable location for electric motor driven units.

Gasoline Engine Compressors

Guidelines for positioning gasoline engine powered units.

Ambient Temperature Considerations

Advises on optimal operating temperatures and environmental factors.

Mounting

Concrete Floors Mounting

Procedure for mounting 3-footed vertical tank compressors to concrete floors.

Truck Bed Mounting

Instructions for mounting gasoline engine compressors on truck beds.

Air Discharge Connections

Air Inlet Connections

Condensate Discharge Piping

Electrical Connections

Permanently Connected Electric Compressors

Details electrical installation and service requirements for permanent connections.

Pressure Switch Wiring

Wiring diagrams for pressure switches on compressors without starters.

IEC Power Connection and Overload Adjustment

Explains IEC power connection and overload adjustment for compressors.

Gasoline Engine Compressor Battery

Guidance on battery requirements and connections for gasoline engines.

Compressor Lubrication

Recommended Lubricant

Specifies recommended lubricants for Ingersoll Rand compressors.

Alternate Lubricants

Lists acceptable alternative lubricants and their properties.

Operation

Daily Pre-Operation Checks

Lists essential checks to perform before operating the compressor daily.

Start-Up (Electric Motor Driven Compressors)

Step-by-step instructions for starting electric motor driven compressors.

Start-Up (Gasoline Engine Compressors)

Step-by-step instructions for starting gasoline engine driven compressors.

Compressor Controls (Electric Motor Compressors)

Automatic Start & Stop Control

Explains the automatic start and stop functionality of the compressor.

Dual Control

Details how to select between automatic and constant speed control.

Pressure Switch Adjustment

Starting Unloading System

Pilot Valve Adjustment

Breather;Unloader By-Pass

Oil Consumption Check

Transporting Compressor (Gasoline Engine Units)

Compressor Controls (Gasoline Engine Compressors)

Constant Speed Control

Explains constant speed control for gasoline engine compressors.

Maintenance

Maintenance Schedule

Provides a schedule for daily, weekly, and monthly maintenance tasks.

Filter Inspection & Cleaning

Oil Change

Belt Adjustment

Checking Belt Tension

Guidance on how to check the tension of drive belts.

Tensioning Belts

Methods for adjusting belt tension on electric and gas engine models.

Electric Drain Maintenance

Tank Inspection

Troubleshooting

General Troubleshooting

Lists common problems and their corresponding check points.

Electric Drain Troubleshooting

Troubleshoots common issues with electric drain valves.

Diagrams & Tables

Fastener Torque Table

Provides torque specifications for various fasteners used in the compressor.

Belt Tension Table

Details belt tension requirements based on model and horsepower.

Electrical Wiring Diagrams

Single Phase Wiring

Wiring diagram for single-phase electric motor compressors.

Three Phase Wiring

Wiring diagram for three-phase electric motor compressors.

Warranty

Limitation of Liability

Ingersoll-Rand 2475 Specifications

General IconGeneral
Horsepower5 hp
Maximum Pressure175 PSI
Tank Capacity80 Gallons
Stages2
Pump TypeReciprocating
Pump MaterialCast Iron
Voltage230 Volts

Related product manuals