To Next PageTo Next PageWhat to do if solenoid condensate valve will not close in Ingersoll-Rand RS18i?
If the solenoid condensate valve in your Ingersoll-Rand Air Compressor will not close, it might be due to debris in the solenoid valve preventing the diaphragm from seating. Remove the solenoid valve, disassemble it, clean it, and reassemble it. Another possibility is a short in the electrical component, so check and replace the power cord or timer as needed.
What to do if inlet valve will not actuate and load package in Ingersoll-Rand Air Compressor?
If the inlet valve of your Ingersoll-Rand Air Compressor will not actuate and load the package, it could be due to a non-functioning blowdown valve, contamination/liquid in the controls tubing, or contamination in either orifice. Examine and clean/replace the affected components as necessary.
What causes fan motor overload in Ingersoll-Rand Air Compressor?
A fan motor overload in your Ingersoll-Rand Air Compressor can occur if the fan is blocked, damaged, or the fan motor is faulty. Remove any blockage and repair or replace any damaged components.
General| Model | RS18i |
|---|---|
| Power Source | Electric |
| Motor Power | 18.5 kW |
| Phase | 3 |
| Control System | Xe-Series Controller |
| Cooling Method | Air-cooled |
| Type | Rotary Screw Compressor |
| Voltage | 230/460 V |
| Tank Capacity | Not applicable |
Required skills and training for compressor maintenance personnel.
Essential safety precautions for compressor operation and maintenance.
Provides a schedule of maintenance tasks based on time or operating hours.
Common compressor symptoms, causes, and their remedies.
List of faults indicated on the XE-70 controller and their causes/actions.
Troubleshooting common issues with the integrated dryer.
Cleaning and testing condensate drains for integrated dryers.
