Ingersoll-Rand Sierra SH 200 User Manual (English)

Questions and Answers:

J
Jeffery WhiteAug 25, 2025
What causes a Ingersoll-Rand Sierra SH 200 to fail to load?
- A
  Anthony FischerAug 26, 2025
  If your Ingersoll-Rand Air Compressor fails to load, start by checking for leaking seals in the hydraulic cylinder. If the cylinder doesn't fully stroke when the 'Load' button is pressed, overhaul the hydraulic cylinder. Also, check for a defective load solenoid valve by removing the tube that runs from the load solenoid valve to the hydraulic cylinder. Start the compressor and press the 'Load' button; if oil doesn't come out of the solenoid valve, replace it.
S
Samantha MejiaAug 28, 2025
How to get rid of water in Ingersoll-Rand Air Compressor system?
- A
  Andre WilsonAug 28, 2025
  If you find water in your Ingersoll-Rand Air Compressor system, start by inspecting the moisture separator/drain trap for defects and clean if required; replace if defective. Check the trap drain and drain piping for any blockages and clean them. Inspect and clean the aftercooler core if it's dirty. Ensure all enclosure panels are in place. If the unit lacks an aftercooler, consider installing one. Finally, ensure the drain line/drip leg is correctly installed, sloping the drain line away from the trap and installing a drip leg.
A
Angel WatkinsSep 1, 2025
Why is my Ingersoll-Rand Air Compressor making so much noise?
- S
  Stacey SmithSep 1, 2025
  If your Ingersoll-Rand Air Compressor has an excessive noise level, inspect and tighten any loose component mountings. Ensure that all enclosure panels are in place. If the compressor itself is defective, contact an authorized distributor immediately and do not operate the unit.
K
Katie MccarthySep 5, 2025
What to do with excessive vibration of Ingersoll-Rand Air Compressor?
- P
  Peter EscobarSep 5, 2025
  If your Ingersoll-Rand Air Compressor is experiencing excessive vibration, inspect and tighten any loose components. If the motor or compressor bearing has failed, contact an authorized distributor immediately and do not operate the unit. Inspect the area for other equipment that may be causing external vibrations.
R
Robert Gillespie Jr.Sep 9, 2025
Why does the pressure relief valve keep opening on my Ingersoll-Rand Sierra SH 200 Air Compressor?
- M
  Melissa HensleySep 9, 2025
  If the pressure relief valve on your Ingersoll-Rand Air Compressor opens, it could be due to the compressor operating over pressure; adjust the controller set points. Alternatively, the valve itself may be defective and require replacement.

Ingersoll-Rand Sierra SH 200 Specifications

General

Model	Sierra SH 200
Drive Type	Direct Drive
Cooling Method	Air Cooled
Phase	3
Maximum Pressure	125 psig
Type	Rotary Screw
Power	200 HP
Operating Pressure	100 PSIG
Voltage	460V

Summary

SAFETY

DANGER!

Hazard that WILL cause DEATH, SEVERE INJURY or substantial property damage if ignored. Instructions must be followed precisely to avoid injury or death.

WARNING!

Hazard that CAN cause DEATH, SEVERE INJURY or substantial property damage if ignored. Instructions which must be followed precisely to avoid injury or death.

CAUTIONS!

Cautions call attention to instructions which must be followed precisely to avoid damaging the product, process or its surroundings.

Ingersoll-Rand air compressors are not designed, intended or approved for breathing air. Compressed air should not be used for breathing air applications unless treated in accordance with all applicable codes and regulations.