Ingersoll-Rand X8I - Service Level Menu Parameters; Service Configuration Settings; Sensor Calibration Procedures; Compressor Configuration (Service)

30
SERVICE LEVEL MENUS
Configuration
S02
01 P> Pressure Units
02 NC Number Of Compressors
03 PM Maximum Pressure Alarm
04 CF Stop Control Function
05 TO Tolerance
06 DA Damping
07 PC Pressure Change Time
08 CA CAP Alarm Inhibit
09 MA Max Cap Restricted Alarm Inhibit
10 AI Auxiliary Input Function
11 AO Auxiliary Output Function
12 ER Error Log Reset
Auxiliary Box Monitoring
S03
01 01 Auxiliary Box #1 Enable
02 02 Auxiliary Box #2 Enable
03 BT RS485 Timeout
Sensor Calibration
S04
01 1O Pressure Offset
02 1R Pressure Range
Compressor Configuration
C03
01 Compressor #1 Configuration
to 8 Compressor #8 Configuration
High Level Menus
Diagnostic Menu 1
D01
01 D1 Digital Input #1 (Di 1)
to
08 D8 Digital Input #8 (Di 8)
09 R1 Output Relay #1 (R1)
to
14 R6 Output Relay #6 (R6)
15 A1 Analog Input #1 (Ai1)
16 A2 Analog Input #2 (Ai2)
17 A3 Analog Input #3 (Ai3)
18 Ao Analog Output (Ao)
Diagnostic Menu 2
D02
01 SI Screen Invert
02 LT LED Panel Test
D03 and D04
Diagnostic menus D03 and D04 have no standard
function and are not shown.
Diagnostic Menu 5
XPM Expansion Module C:5-8 Diagnostic Menu
only available when applicable EXP Expansion Box is
installed and registered (detected) by the X8I.
D05
01 D1 Digital Input #1 (Di 1)
to
08 D8 Digital Input #8 (Di 8)
09 R1 Output Relay #1 (R1)
to
14 R6 Output Relay #6 (R6)
15 Ao Analog Output (Ao)