Inglis IFR42001 User Manual

To use washer again:
1. Flush water pipes. Reconnect water inlet hoses to faucets.
Turn on both water faucets.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug in washer or reconnect power.
3. Run the washer through the Regular/Normal cycle with
1/4the normal recommended amount of HE detergent to clean
out antifreeze.
To transport the washer:
1. Unplug washer or disconnect power.
2. Remove drain hose from the standpipe or laundry tub. Attach
the drain hose to the rear panel clips.
3. Shut off both water faucets.
4. Disconnect the water inlet hoses from faucets and rear of
washer. Drain the hoses and place them inside the washer
drum.
5. Place a pan or towel under the filter door, as a small amount of
water could spill. Open the filter door and remove the lint filter
to drain. See "Cleaning the lint filter" in the "Cleaning Your
Washer" section.
6. Reinstall the lint filter and close the filter door.
IMPORTANT: Call your local service center for assistance.
Transport bolts should be installed prior to moving. The washer
must be transported in the upright position to avoid suspension
and structural damage.
Reinstalling the washer:
1. Follow the "Installation Instructions" to locate, level and
connect the washer.
2. Run the washer through the Regular/Normal cycle with 1/4the
normal recommended amount of HE detergent to clean the
washer and remove the antifreeze, if used.
TROUBLESHOOTING
Firsttry the solutions suggested hers to possibly avoid the cost of a service call...
Washer odor
• Do you use High Efficiency (HE) detergent?
Use only High Efficiency (HE) detergent in this washer.
Have you cleaned the washer interior using the
recommended procedure? Your washer interior should be
cleaned at least once per month to reduce or avoid any
accumulation of mold or mildew odors. See "Washer Care"
for interior cleaning procedure.
• Inspect the interior of the washer for lint and other debris that
may accumulate on the basket and rubber bellows. Remove
and dispose of any accumulation as necessary.
• Leave the washer door open between cycles to allow the
washer interior to dry out.
Washer won't start
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Check the following:
Is the power cord plugged into a grounded 3 prong outlet?
Is the washer door firmly closed?
Has a cycle been selected, but START has not been pressed?
Was the door open after completion of last cycle?
16

Inglis IFR42001 Specifications

General

Brand	Inglis
Model	IFR42001
Category	Washer
Language	English