Device Operation
(How to Finish the Settings without APP)
Preparations
1) Complete the hardware installation.
2) Install 4 AAA batteries.
3) (After the first hardware installation, be sure to restore the factory
settings) Press and hold the reset button in the lower right corner of the
battery compartment for 5 seconds.
Note: Wake up the keyboard by touching and holding it for 2 seconds.
1. How to Add Fingerprints, Passwords, and IC Cards
Note: The local input fingerprint, password, and IC card can all be
administrators. The first three users are administrators.
Press "2" and then " " to add:
1) Add Fingerprint: Enter your fingerprint as prompted. Each fingerprint
need to be entered 3 times. Note that to ensure the integrity of the fingerprint,
you should enter a different part of your fingerprint each time.
2) Add Password: Enter a 6-digit password. Password registration needs
to be entered 2 times.
3) Add IC Card: Hold the IC card close to the card sensing area until you
hear a sound indicating success.
4) Press the key to quit adding users.
2.Optional Functions
1) Automatic Locking
After 10 failures to open, the system will automatically lock for 3 minutes.
2) Normal Open Mode
Press "3" and then " " to enter the Normal Open mode. (Operation timeout:
10 seconds) If you have added an administrator, it requires verification of
administrator information. Press the key to quit the Normal Open mode.
3) Voice Language Switch
Press "4" and then " " to switch the voice language between Chinese and
English. (Operation timeout: 10 seconds)
4) Volume Adjustment
Press "5" and then " " to enter volume setting.
(Operation timeout: 10 seconds)
Then, press "0" and " " to mute the sound; press "1" and " " to choose
the lowest volume; press "2" and " " to choose low volume; press "3" and
" " to choose high volume; press "4" and " " to choose the highest volume.
5) Door Opening Direction (must be set in initialization state)
Press "7" and then " " to set the door to open left or right. If the deadbolt is
locked (when exposed), the calibration is done automatically and all lights
go out. If the deadbolt is unlocked (when not exposed), turn the knob left or
right to lock the deadbolt and the lock will automatically calibrate. All lights
will go out after calibration succeeds. After calibration, users can unlock
once with fingerprint verification.
6) Factory Reset
Method 1: Press and hold the reset button in the lower right corner of the
battery compartment for 5 seconds to restore factory settings.
Method 2: Press "6" and then " " to enter the factory reset after
disconnecting all Bluetooth pairings. (Operation timeout: 10 seconds)
Note: After this operation, the data entered in the app will all be invalid.
50
To Next Page
Loading...