Inner Range Integriti Elite User Manual

12
IntegritiIntegriti
IntegritiIntegriti
Integriti LCD Terminal Keypads User Manual.






Turning Area/s OFF.
Logon to the Terminal as described earlier.
(PIN code + <OK>)
After the greeting (if enabled), the display will show
the Area Status etc. To select another Area see
“AREA SELECTION” on the next page.
At the “Press OFF” prompt, turn the displayed Area
(or Area List) OFF by pressing the <OFF> key.
The display will alter accordingly to indicate that
the operation was successful.
If you are allowed to control more than one
Area:
-DISPLAY MODE.
The Display mode can be changed from Single
AREA to AREA LIST and vice versa. Press the
<LEFT ARROW> key once or twice until you see
the text “Area List On/Off” on the bottom line.
By using AREA LISTS, you can turn OFF all the
Areas in the List that you are allowed to control,
with a single operation.
Once you have Logged on to a Terminal, and have seen the Area status with the “Press
Off” or “Press On” message, you may perform the Area OFF or ON operations.
Remember: You have a limited time to turn an Area OFF once you have entered the
Area (Usually 30-90 seconds). Ask the Installer for the Entry time used in your system.












- ,
NOTE: Quick Arm/Disarm. Your system may be configured to allow a nominated
Area to be controlled simply by entering your PIN code, then the OFF or ON key.
i.e. OK key not required. (Elite LCD Terminal V8.3 or later)

Inner Range Integriti Elite Specifications

General

Brand	Inner Range
Model	Integriti Elite
Category	Keypad
Language	English