Advice for energy saving
Problem diagnosis
- Always keep filters clean (see Maintenance and
Cleaning chapter).
- Keep doors and windows closed
- Avoid direct sunlight in the room (use curtains, pull
down the blinds or close the shutters)
- Do not obstruct the air flow (inwards and outwards)
as, on top of affecting performance, it prevents the
system from working correctly and it may cause
irreparable damage to the appliance.
It is very important that the User is capable of distinguishing
problems or anomalies from normal functioning. The most
common problems can be solved by the User following
simple procedures (see Troubleshooting paragraph),
whereas it is necessary to contact the Service Centre for
some of the alarms.
We would like to remind you that any reparation attempt
performed by unauthorised personnel immediately invalidates
any warranty.
- The compressor does not start again before a certain period
of time (approximately 3 minutes from the previous stop). The
delay between stops and reactivations has been arranged in
order to protect the compressor from too frequent activations.
- During heating mode, it is possible that warm air is dispensed
a few minutes after the compressor has been activated. If the
fan were to start together with the compressor, cold air would
be dispensed to the room (which could lead to discomfort for
those in the room) as the appliance is not fully operational yet.
If you lose the remote control, if it brakes or if the batteries run out,
the appliance can be managed using the touch-screen display.
Operating aspects that must not be interpreted as problems
Managing the appliance if the remote control is not available
To Next Page
Loading...
