Operating Manual IP Telephone IP200 - 28 -- 28 -
6.3. Call waiting
1. This function allows you to control call waiting while engaged in a telephone call.
2. In the initial state, press the following keys: Menu ,
the function key next to User Setup.
Use the function key next to Call waiting, to choose between the following call
waiting states:
Off The call waiting function is switched off. The caller receives a busy
signal and the called party receives no call-waiting signal.
On - once A call-waiting tone sounds once.
On - mute No call-waiting tone; you only receive visual notification of a new call.
On - def. Call waiting duration and signal are in accordance with the country-
specific standard.
Note:
You can determine the country-specific standard as
described. In the initial state, press the following keys:
- Menu
- Function key next to Administration
- Function key next to Registration
- Function key next to Option
Use the function key next to Tones to configure the
country-specific standard for your IP telephone as desired.
6.4. Calling line identification presentation (CLIP)
This function is used to switch the calling line identification presentation feature for
outgoing calls on or off. The setting applies for all subsequent calls, in so far as settings
are not made for individual calls.
1. In the initial state, press the following keys: Menu , function key next to
User Setup.
2. Use the function key
next to Number Present to switch this feature on or off.
7. Phone Setup menu
The Phone Setup menu relates to the IP telephone hardware, irrespective of the user.
Tip:
Operation is faster if you assign calling line identification presentation to a
function key .
To Next Page
Loading...
