Operating Manual IP Telephone IP200 - 33 -- 33 -
8.1. Register co-users
A co-user can be registered with your IP telephone as follows:
1. In the initial state, press the Menu key followed by the function key next to
User List.
2. Press the function key next to a free line in the list (1-6).
3. To register a co-user, press the function key next to Registration and then the
function key next to Setup.
4. Now press the function key next to
¾ Name:” to enter the name of the co-user.
¾ “Number:” to enter the number.
¾ “Passw.” to enter the co-user’s password.
¾ “VoIP Gatekeeper”. Specify the following desired values as described:
Gatekeeper
IP
If several gatekeepers are to be active at one address, a particular
gatekeeper is identified amongst them using the name entered
here.
Gatekeeper
IP Address
Here, you specify the IP address at which the first responsible
gatekeeper can be reached.
Gatekeeper
IP Address
There should be a further gatekeeper in the network in case the
first gatekeeper is unavailable. You enter the IP address of this
gatekeeper here.
¾ “Options”, Tones: Here, you set the country-specific tone standard.
8.2. Unregister or delete co-user
To unregister the active user or even delete them from the list, press the function key
next to the desired co-user. Then select the function key next to Registration and
confirm the Unregister or Delete function with the relevant function key .
8.3. Switch user
If several users are registered with your telephone, incoming calls are signalled for all
users with specification of the called identity on the display. Outgoing calls are set up
with the data of the active user.
To switch the active user, press the function key next to the required entry and
confirm the new user with the function key next to Activate.
To Next Page
Loading...
