Need help?Do you have a question about the inogeni TOGGLE and is the answer not in the manual?
Describes the default mode, where the device automatically switches to the last connected PC.
Explains how to manually force PC selection and turn off PCs.
Provides a comprehensive list of serial commands with arguments, return values, and function descriptions.
Shows the pinout for connecting to the serial controller (TX, GND, RX).
Details commands for GPIN mode, settings, system management, and help functions.
Explains the factory default pulse mode where GPIN transitions trigger PC changes.
Describes the level mode where a specific level on GPIN selects a PC.
Introduces the Control App for monitoring firmware, upgrading, and configuring the unit.
To Next Page
General