Inovalley WIRELESS POOL THERMOMETER - 4.6 Multi-Channel Operation; 4.6.1 Multi-channel Sensor Initialization

Version 1.4 Page 9
min/maxmode.Theminimumwatertemperatureandindoortemperaturewillbedisplayed.
Press the CLEAR button (on the top of the display) to clear the minimum values to the
currentmeasuredvalues.
2. MaximumValues.PresstheMIN/MAXbuttonagain,andthemaximumwatertemperature
andindoortemperaturewillbe
displayed.PresstheCLEARbutton(onthetopofthedisplay)
toclearthemaximumvaluestothecurrentmeasuredvalues.
3. PresstheMIN/MAXbuttonagaintoexitthemin/maxmode.

4.5 °C/°FUnitsofMeasure
Totogglebetween°C/°Ftemperatureunitsofmeasureonthedisplay,presstheC/Fbuttonon the
backofthedisplay.
4.6 Multi‐ChannelOperation
The station supports up to 3 remote thermometers (one is included). The optional sensors can be
purchasedatInovalley.
4.6.1 Multi‐channelSensorInitialization
Placethemultipleremotesensorsabout10feetfromtheconsole.Powerupthesensorsandconsole
inthefollowingorder:
1. Power up the first remote thermometer and set the channel number dip switches, as
describedinSection2.3.VerifythedisplayreadsChannel1.
2. Power up the second
 remote thermometer and set the channel number dip switches, as
describedinSection2.3.VerifythedisplayreadsChannel2.
3. Power up the third remote thermometer (if available) and set the channel number dip
switches,asdescribedinSection2.3.VerifythedisplayreadsChannel3.
4. Powerup
theconsolelastandwaitabout3minutes.PresstheCHANNELbuttononthetop
ofthedisplaytoverifyallthreesensorsarecommunicatingtotheconsole.
5. Onceverified,youarereadytoinstalltheremotethermometers.
4.6.2 Multi‐channelSensorAccuracyNote
Verifythetemperaturevaluesmatchcloselywiththeconsoleandsensorarrayinthesamelocation.
Thesensorsshouldbewithin4°F(theaccuracyis±2°F).

Allowabout30minutesforallsensorstostabilize.
4.7 Maintenance
We recommend inspecting the gasket inside the lid of the floating thermometerwith each battery
change.Moistenwithpoolgasketlubricantavailablefrommostpoolstores.Inspectforanymoisture
insidethefloatingthermometer.Replacethegask etevery1year.
Toreplacethegasket,slidethegasket overthefloat
potionofthefloatingthermometerandinsert
intothegasketguideonthelid.

5. GLOSSARYOFTERMS
Term Definition
Accuracy Accuracyisdefinedastheabilityofameasurementtomatchtheactual