‑26‑
When installed on a DIN rail other than the recommended one (especially the one
whose thickness is not 1.0 mm), the product will not fit in place as the mounting hook
does not work.
■ Installing the master
1. Align the controller with the DIN rail and push the controller in the direction
indicated by the arrow until you hear a clicking sound, as shown below.
2. Make sure the DIN rail mounting hook of the controller is locked. The locked and
unlocked states of the mounting hook are shown below.
● If the mounting hook is pressed down, it is locked.
● If the mounting hook is lifted up, it is unlocked.
Press down the mounting hook to lock the controller to the DIN rail.
To Next Page
Loading...
