‑8‑
● Do not connect the input power supply to the output end of the equipment. Failure to
comply can result in equipment damage or even a fire.
● When connecting a drive to the motor, make sure the phase sequence of the drive and
motor are consistent to prevent motor reverse rotation.
● Cables used for wiring must meet cross sectional area and shielding requirements. The
shield of the cable must be reliably grounded at one end.
● Ensure that all cables are connected correctly. Cable sheath is not damaged, and no
screw or washer is left inside the equipment. Otherwise, electric shock or equipment
damage may occur.
● During wiring, follow the proper electrostatic discharge (ESD) procedure and wear an
antistatic wrist strap. Failure to comply can result in damage to the equipment or
internal circuits.
● In wiring the control circuit, use shielded twisted pair cable and connect the shield to the
PE terminal. Otherwise, the equipment may not function properly.
Power-on
● Before power‑on, check that the equipment is installed properly, the wiring is secure and
the motor can be restarted.
● Before power‑on, check that the power supply meets equipment requirements to
prevent equipment damage or even a fire.
● After power‑on, do not open the cabinet door or protective cover of the equipment. Do
not touch any wiring terminals, or remove any part of the equipment at power‑on.
Failure to comply will result in an electric shock.
To Next Page
Loading...
Need help?
General
