3 Keypad and Display
3
- 33 -
Chapter 3 Operation and Display
3.1 Introduction to Keypad
Figure 3-1 Diagram of the keypad
Display
MODE SET
I
2
P
-
S
5
5
R
6
0
S
Drive model and barcode
The keypad on the servo drive consists of the 5-digit 7-segment LEDs and keys. The keypad is used for
display, parameter setting, user password setting and general functions operations. When the keypad is
used for parameter setting, the functions of the keys are described as follows.
Table 3-1 Functions of keys on the keypad
Key Name Function Description
MODE
Switch between all modes.
Return to the upper-level menu.
UP Increase the number indicated by the blinking digit.
DOWN Decrease the number indicated by the blinking digit.
SHIFT
Shift the blinking digit.
View the high digits of the number consisting of more than 5 digits.
SET
Switch to the next-level menu.
Execute commands such as storing parameter setting value.
3.2 Keypad Display
The keypad can display the running status, parameter, faults, and monitored information during running of
the servo drive.
● Status display: Displays the current servo drive status, such as servo ready or running.
● Parameter display: Displays function codes and their values.
● Fault display: Displays the fault and warnings occurring in the servo drive.
● Monitoring display: Displays the current running parameters of the servo drive.
To Next Page
Loading...
Need help?
General
