Inovance MD380 Series

Description of Function Codes
MD380 User Manual
- 188 -
Function Code Parameter Name Setting Range Default
F7-10 Performance software version - -
F7-11 Function software version - -
F7-12
Number of decimal places for
load speed display
8QLW's d
igit: Number of decimal
SODFHVRI8
1
0: 0 decimal place
1: 1 decimal place
2: 2 decimal places
3: 3 decimal places
Ten's digit: Number of decimal
SODFHVRI88
1: 1 decimal place
2: 2 decimal places
 8QLWVGLJLW/
1XPEHURIGHFLPDOSODFHVRI8
It is used to set the number of decimal places for load speed display. The following
gives an example to explain how to calculate the load speed:
$VVXPHWKDW)/RDGVSHHGGLVSOD\FRHI¿FLHQWLVDQG)LVGHFLPDO
SODFHV:KHQWKHUXQQLQJIUHTXHQF\RIWKH$&GULYHLV+]WKHORDGVSHHGLV
[ GLVSOD\RIGHFLPDOSODFHV
If the AC drive is in the stop state, the load speed is the speed corresponding to the set
frequency, namely, "set load speed". If the set frequency is 50.00 Hz, the load speed in
WKHVWRSVWDWHLV[ GLVSOD\RIGHFLPDOSODFHV
 7HQ¶VGLJLW1XPEHURIGHFLPDOSODFHVRI88
,WLVXVHGWRVHWWKHQXPEHURIGHFLPDOSODFHVRI88
Function Code Parameter Name Setting Range Default
F7-13 Accumulative power-on time 0–65535 h 0 h
It is used to display the accumulative power-on time of the AC drive since the delivery. If the
time reaches the set power-on time (F8-17), the terminal with the digital output function 24
EHFRPHV21
Function Code Parameter Name Setting Range Default
F7-14 Accumulative power consumption ±N:K /
It is used to display the accumulative power consumption of the AC drive until now.
Function Code Parameter Name Setting Range Default
F7-15 Temporary performance software version - -
F7-16 Temporary function software version - -
efesotomasyon.com