EasyManua.ls Logo

Inovance MD380 Series

Inovance MD380 Series
304 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MD380 User Manual Mechanical and Electrical Installation
- 39 -
6) Terminal
PE
7KLVWHUPLQDOPXVWEHUHOLDEO\FRQQHFWHGWRWKHPDLQHDUWKLQJFRQGXFWRU2WKHUZLVH
it may cause electric shock, mal-function or even damage to the AC
drive.
Do not connect this terminal to the neutral conductor of the power supply.
The impedance of the PE conductor must be able to withstand the large short-
circuit current that may arise when a fault occurs.
Select the size of the PE conductor according to the following table:
Cross-sectional Area of a
Phase Conductor (S)
Min. Cross-sectional Area of
Protective Conductor (Sp)
6PP
2
S
16 mm
2
6PP
2
16 mm
2
35 mm
2
< S S/2
You must use a yellow/green cable as the PE conductor.
7) Requirements on upstream protection device
Install a proper protection device on the power input side to provide protections on
overcurrent, short-circuit and electrical solation.
:KHQVHOHFWLQJWKHSURWHFWLRQGHYLFH\RXVKRXOGFRQVLGHUWKHFXUUHQWFDSDFLW\
of the power cable, system overload capacity and short-circuit capacity of the
equipment upstream power distribution. Generally, make selection according to
the recommended values in section 8.4.
3.2.3 Description of Control Circuit Terminals
Ƶ Terminal Arrangement of Control Circuit
+24V
+10V AI1 AI2 DI1 DI2 DI3 DI4 DI5 &20
GND GND $21CME&20 '21FM 23 T/A T/B T/C
Ƶ Function Description of Control Circuit Terminals
Table 3-3 Description description of control circuit terminals
Type Terminal Name Function Description
Power
supply
+10V-GND
External +10 V
power supply
Provide +10 V power supply externally. Generally,
it provides power to the external potentiometer
with resistance range of 1–5 k¡
.
Maximum output current: 10 mA
9&20
External +24 V
power supply
Provide +24 V power supply externally. Generally,
LWSURYLGHVSRZHUWRWKH','2WHUPLQDOVDQG
external sensor.
Maximum output current: 200 mA
23
Input terminal of
external power
supply
Connect to +24 V by default.
:KHQ',',QHHGWREHGULYHQE\H[WHUQDO
VLJQDO23QHHGVWREHFRQQHFWHGWRH[WHUQDO
power supply and be disconnected from +24 V.
efesotomasyon.com

Table of Contents

Related product manuals