Inovance MD500-EN1 - EMC Wiring

3 Ethernet/IP Communication Protocol
- 14 -
&UIFSOFU*1
.BTUFS
1 1
1 1 1
.%&/
4MBWF
1 1
.%&/
4MBWF
1 1
1 1 1 1 1 1
.%&/
4MBWF
1 1
.%&/
4MBWF
1 1
.%&/
4MBWF
1 1
.%&/
4MBWF
1 1
/FUXPSL
TXJUDI
/FUXPSL
TXJUDI
/FUXPSL
TXJUDI
Figure 3-3 Tree topology
2.2.2 EMC Wiring
■
During on-site installation and commissioning, the signal cables and power cables
must be laid in di󶍽erent ducts. Never bundle the signal cables and power cables
together to prevent communication interference.
■
Motor enclosure must be connected to PE of the AC drive. Meanwhile, the
grounding cable on the motor housing side must be connected properly. Failure to
comply will result in poor grounding e󶍽ect.
■
Shielded cables are recommended. Connect the shield to PE of the AC drive.